Yokogawa 414 Batch Controller Manuale Utente Scaricare il pdf (Pagina 22)

20 Operation

3.3.2 Filtering

Frequency fluctuations caused by pulsating flow through a flowmeter, often makes

the Rate impossible to read with any precision. The Batch Controller has a digital

filter which will average out these fluctuations and enable the Rate to be read to

four digit accuracy. The ability to select a suitable filtering level means that highly

accurate and stable readings can be obtained without excessive lag.

The diagram below shows a pulsating signal input together with the effect of

filtering.

As a guideline to the degree of filtering to be used, the following table shows the

response to a step change in input. The value, A, is the filter constant which is

programmed during the Calibration routine. The times for the display value to

reach 90% and 99% of full swing are given in seconds, for different values of A.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 58 59

Nessun commento

Yokogawa 414 Batch Controller Manuale Utente Pagina 22